Agilent Technologies N9360A, Programming Manual

Page: 25 / 180

Preparing for Use
3
N9360A Multi UE Tester W-CDMA Programming Manual 3-5
Connecting to Controller
Ethernet
An Ethernet connector is provided with the Tester as the
Ethernet interface to a controller.
• If your controller (PC) has an Ethernet connector, use the
UTP (10BASE-T/100BASE-TX) cross-over cable between the
controller (PC) and the Tester directly or two straight cables
among the HUB, the controller and the Tester.
GP-IB
An IEEE-488 (GP-IB) controller (Option E00) is provided with
the Tester as the GP-IB interface to a controller.
• If your controller (PC) has an IEEE-488 (GP-IB) connector,
use the IEEE-488 (GP-IB) cable between the controller (PC)
and the Tester.
RS-232C
A DB-9 male connector (Option E01) is provided with the Tester
as the serial interface to a controller.
If your controller (PC) has a serial interface, refer the following
explanations.
• If your controller (PC) has a DB-9 male connector, use the
9-pin female to 9-pin female RS-232C null modem cable
between the controller (PC) and the Tester.
• If your controller (PC) has a DB-25 male connector, insert the
9-pin male to 25-pin female adapter between the RS-232C
cable and the 25-pin male connector.
An example of connection of these cable and adapter are shown
in
Figure 3-4 as follows.
NOTE
Ignore the control lines (CTS, DSR, DCD and RI) status with the controller.