Agilent Technologies N9360A, Programming Manual

Page: 118 / 180

5-72 N9360A Multi UE Tester W-CDMA Programming Manual
5
Programming Command Reference
•
<real 3>
(up to 4 letters) is the measured data ranging
from
0.00
to
9.99
in MHz. If measurement result is out of
range or OBW is not measured, the value
9.99
is returned.
This command is valid only when the W07 option is installed in
the Tester. If the W07 option is not installed in the Tester, an
execution error occurs.
Signal Generator Subsystem
The Signal Generator subsystem commands are used to set and
read the controls and parameters of the Signal Generator
functions.
RFGenerator Subsystem Command Reference
Radio System
RFGenerator:RFORmat W_CDMA
RFGenerator:RFORmat?
This command selects a Radio System to be tested. Only
W-CDMA
is available.
RFCH
RFGenerator:CHANnel <int>
RFGenerator:CHANnel?
This command sets the channel number. The allowable range
and preset values are as follows:
The range of the value is same as that of the command
parameter.
RFGenerator:CHANnel <int 1>,<int 2>
Table 5-13
RFCH Allowable Range and Preset Value
Band Allowable Range Preset Value
1 10550 to 10850 10562
6 4375 to 4425, 1037, 1062 4387