Agilent Technologies 86100A, Programmer'S Manual, Page: 248 / 366

18-6
Measure Commands
AMPLitude:ISIVsbit:BITS?
tude:UNITs” on page 18-11 . Use the query “SINTegrity:PATTern?” on page 18-41 to return
the corresponding bit sequence. Use the query “AMPLitude:ISIVsbit:BITS?” on page 18-6 to
return a list of corresponding bits for which AMPLitude:ISIVsbit? has returned values.
Restrictions
86100C (software revision A.07.00 and above) with Jitter Mode including Advanced Ampli-
tude Analysis/RIN/Q-Factor application.
Example 10 OUTPUT 707;”:MEASURE:AMPLITUDE:ISIVSBIT?”
Returned Format [:MEASure:AMPLitude:ISIVsbit] <block data><NL>
AMPLitude:ISIVsbit:BITS?
Query MEASure:AMPLitude:ISIVsbit:BITS?
Returns definite-length block data. The data block contains the list of bits for which AMPLi-
tude:ISIVsbit? has returned values. Each bit value is a 32-bit integer (4 bytes). The data block
is followed by a linefeed termination character (0A hex).
Restrictions 86100C (software revision A.07.00 and above) with Jitter Mode including Advanced Ampli-
tude Analysis/RIN/Q-Factor application.
Example 10 OUTPUT 707;”:MEASURE:AMPLITUDE:ISIVSBIT:BITS?”
Returned Format [:MEASure:AMPLitude:ISIVsbit:BITS] <block data><NL>
AMPLitude:ISIVsbit:HIGHest?
Query MEASure:AMPLitude:ISIVsbit:HIGHest? {ONE | ZERO}
Returns highest amplitude bit (for a one or zero level) for which AMPLitude:ISIVsbit? has
returned values. The bit value is a 32-bit integer (4 bytes).
Restrictions
86100C (software revision A.07.00 and above) with Jitter Mode including Advanced Ampli-
tude Analysis/RIN/Q-Factor application.
Example 10 OUTPUT 707;”:MEASURE:AMPLITUDE:ISIVSBIT:HIGHEST?”
Returned Format [:MEASure:AMPLitude:ISIVsbit:HIGHest] <integer><NL>
AMPLitude:ISIVsbit:LOWest?
Query MEASure:AMPLitude:ISIVsbit:LOWest? {ONE | ZERO}
Returns lowest amplitude bit (for a one or zero level) for which AMPLitude:ISIVsbit? has
returned values. The bit value is a 32-bit integer (4 bytes).
Restrictions
86100C (software revision A.07.00 and above) with Jitter Mode including Advanced Ampli-
tude Analysis/RIN/Q-Factor application.
Example 10 OUTPUT 707;”:MEASURE:AMPLITUDE:ISIVSBIT:LOWEST?”
Returned Format [:MEASure:AMPLitude:ISIVsbit:LOWest] <integer><NL>
AMPLitude:LEVel:CIDigits:LAGGing
Command MEASure:AMPLitude:LEVel:CIDigits:LAGGing <num_digits>
Specifies the minimum number of lagging consecutive identical digits to be uses in defining
the one and zero levels.