Agilent Technologies 86100A, Programmer'S Manual, Page: 217 / 366

15-5
Limit Test Commands
SOURce
cleared and the new measurement to be added. All measurements may be cleared by execut-
ing the :MEASure:CLEar command. Use the :MEASure: RESults? query to get the names of
the currently selected measurements. When writing new code, this command (
SINTegrity)
is
the recommended replacement for the command “JITTer:SELect” on page 15-2 .
Restrictions 86100C (software revision A.07.00 and above) with Jitter Mode including Advanced Ampli-
tude Analysis/RIN/Q-Factor application.
Returned Format [:LTESt:SINTegrity:SELect] {RJ | PJ | PJRMS | DJ | TJ | DDJ | DCD | ISIJ | TI1 | TI0 | RN1 | RN0 | DI1 | DI0 | ISI1 |
ISI0 | PI1 | PI0 | PIRMs1 | PIRMs0 | SAMplitude | EOPening | Q | RINoise | BERFloor}<NL>
Example 10 OUTPUT 707;”:LTEST:SINTEGRITY:SELECT RN”
SOURce
Command :LTESt:SOURce {1 | 2 | 3 | 4}
This command selects the current source for the ULIMit, LLIMit, MNFound, and FAIL com-
mands. It selects one of the active measurements as referred to by their position in the mea-
surement window on the bottom of the screen. Source 1 is the measurement on the top line,
2 is on the second line, and so on. As a measurement is activated, the associated measure-
ment limit test is programmed according to default values expressed by the following script:
:LTESt:SOURce <N>
:LTESt:FAIL OUTSIde
:LTESt:LLIMIt -10
:LTESt:ULIMIt 10
:LTESt:MNFound FAIL
:LTESt:RUNTil FAILUres, 1
Before a measurement limit test is initiated, you must make the necessary adjustments to the
default values otherwise these values will be used during the limit test.
Example The following example selects the first measurement as the source for the limit testing com-
mands.
10 OUTPUT 707;”:LTEST:SOURCE 1”
Query :LTESt:SOURce?
The query returns the currently selected measurement source.
Returned Format [:LTESt:SOURce] {1 | 2 | 3 | 4} <NL>
Example The following example returns the currently selected measurement source for the limit test-
ing commands.
10 DIM SOURCE$[50]
20 OUTPUT 707;”:LTEST:SOURCE?”
30 ENTER 707;SOURCE$
See Also Measurements are started in the Measurement subsystem.
SSCReen
Command :LTESt:SSCReen {OFF | DISK [,<filename>]}