10-24 ADS Manual
SIM card properly seated and secured in the holder
10.
Replace the cap onto the SIM card enclosure, and snap the
locks in place to secure the cap.
11.
Replace and reconnect the plastic tie between the locks holding
the cap on the SIM card enclosure.
12.
Change the APN name (
when necessary
).
13.
Connect an ADS USB Serial Interface cable (ADS p/n 8000-
0337) to the
COMM + EXT PWR
port on the monitor (
for
battery powered monitors
) or a standard A-to-B USB cable to
the
USB
port on the ExPAC (
for externally-powered monitors
).
Attach the other end of the USB cable to your laptop computer.
14.
Reactivate the monitor through
Qstart
.
Note:
You must reactivate the monitor through a direct
(
serial
) connection before you can resume wireless
communications following SIM card replacement.
15.
Establish communication with the monitor remotely to verify
communication.
16.
Recoil and secure the antenna cable to the cable tie mount
using a cable tie, if necessary. Refer to
Installing the Antenna
in
Chapter 4
,
Communication
, for more information.
Summary of Contents for Intrinsically-Safe TRITON+
