ADS Intrinsically-Safe TRITON+, Installation, Operation And Maintenance Manual, Page: 295 / 424

Analog and Digital I/O 8-9
with the analog output parameters that indicate the values or
measurements that correspond to the analog signals within the
4-20mA range. Refer to
Chapter 6 , Configuration and
Activation , for instructions on supplying this information in
Q start .
3. Configure the device or instrument receiving the analog signals
with the range and engineering units corresponding to the 4-
20mA from the
.
4. Connect the analog output wires to the ADS XIO in the
following way:
Note: Make sure the power is turned off to the third-party
device and XIO.

Release the latches and open the clear, front door on the
XIO.

Run the wires up through the left cable gland on the XIO
into the enclosure. ADS recommends using 18-gauge
wiring.
You may need to loosen the plastic nut on the
cable gland on the outside of the XIO to feed the wires
through.