ADS Intrinsically-Safe TRITON+, Installation, Operation And Maintenance Manual, Page: 324 / 424

Maintenance and Troubleshooting 10-3

Compressed air

Flat head screwdriver and assorted wrenches

Rubber stretch electrical tape

Magnet ( for troubleshooting wireless communications )
Inspecting the Monitor
Perform the following inspections during site visits or from a
remote location (when applicable):

Inspect the monitor mounting bracket to verify that the bracket
and bolts are free of heavy corrosion and the bolts are tightened
and secure.

Verify that the four bolts holding the monitor together are snug,
and tighten any loose bolts.

Verify that the monitor is mounted securely in the manhole.

Inspect the monitor for general integrity. Verify that nothing
more than surface corrosion is present and that the monitor has
no obvious mechanical defects. Replace the monitor if
necessary.

Perform monitor data confirmations. These can occur from a
remote location where wireless communication is available.

Review the applicable logs in Qstart
™
to verify the status of the
monitor clock, communications, firmware, battery pack, and
temperatures.

Clean the monitor and sensors regularly with a soft bristle
brush and paper towels.
However, do not use detergent!
Note:
Please use special care when cleaning the crystals
on the Surface Combo Sensor. They are covered with a
Teflon
®
coating. Therefore, do not use a wire brush or
other abrasive, metallic device to clean these sensors.