Accom APR Attache, User Manual

Page: 146 / 164

Accom APR
yy$WWDFKp Digital Disk Recorder
132 User Guide
2. Toggle between the two following video output choices:
Â
D1 & RGB
Selects the Serial Digital Video (SDI) output, with RGB
format on the CAV output.
Â
D1 & Beta
Selects the Serial Digital Video (SDI) output, with
YUV (Betacam) format on the CAV output.
The active video output format may be changed at any time during operation.
❏
F3 Play Ref
This parameter is used to select the desired playback reference, which is applied to
the video outputs of the Attaché. A proper video signal must be present at the
appropriate input connector, in order to make proper recordings on Attaché.
1. To select the system reference:
ƒ
Press
Play Ref
2. Toggle between the five following video reference choices:
Â
Ref In
Locks the Attaché system to the incoming reference
signal, as found on the REF connector on the rear of
the Attaché chassis.
127(
The “Digital In” selection on softkey F3 Play Ref is possible only if softkey
F1 Video In is set to “Digital D1”.
Â
Digital In
Locks the Attaché system to the input serial digital
video signal, as found on the DIGITAL VIDEO IN
connector on the rear of the Attaché chassis.
127(
“Analog Sync” & “Analog Grn” selections on softkey F3 Play Ref are
possible only if softkey F1 Video In is set to “Analog Beta” or “Analog
RGB”.
Â
Analog Sync
Locks the Attaché system to the sync portion of the
component analog video (CAV) input signal, as found