ABB ACS880-07, Hardware Manual

Page: 133 / 274

￭ Default I/O diagram of the inverter control unit (A41)
„
Drive-to-drive link XD2D
Drive-to-drive link
1)
B 1
A 2
BGND 3
Shield 4
RS485 connection X485
Not in use
B 5
A 6
BGND 7
Shield 8
Relay outputs XRO1…XRO3
Ready
250 V AC / 30 V DC
2 A
NC 11
COM 12
NO 13
Running
250 V AC / 30 V DC
2 A
NC 21
COM 22
NO 23
Faulted(-1)
250 V AC / 30 V DC
2 A
NC 31
COM 32
NO 33
Safe torque off XSTO, XSTO OUT
Safe torque off input. Both circuits must be closed for the
drive to start.
2)
OUT 1
SGND 2
IN1 3
IN2 4
Safe torque off output to inverter modules
2)
IN1 5
SGND 6
IN2 7
SGND 8
Digital inputs XDI
Stop (0) / Start (1) DI1 1
Forward (0) / Reverse (1) DI2 2
Reset DI3 3
Acceleration & deceleration select
3)
DI4 4
Constant speed 1 select (1 = on)
4)
DI5 5
By default not in use. DI6 6
Run enable 5) DIIL 7
Digital input/outputs XDIO
Output: Ready DIO1 1
Output: Running DIO2 2
Digital input/output ground DIOGND 3
Digital input/output ground DIOGND 4
Auxiliary voltage output XD24
+24 V DC 200 mA 6) +24VD 5
Digital input ground DICOM 6
+24 V DC 200 mA 6) +24VD 7
Digital input/output ground DIOGND 8
Ground selection switch
7)
DICOM=DIOGND
Analog inputs, reference voltage output AI
10 V DC, R
L
1…10 kohm +VREF 1
-10 V DC, R
L
1…10 kohm -VREF 2
Ground AGND 3
Speed reference
0(2)…10 V, R
in
> 200 kohm
8)
AI1+ 4
AI1- 5
By default not in use.
0(4)…20 mA,
R
in
= 100 ohm
9)
AI2+ 6
AI2- 7
Analog outputs AO
Motor speed rpm 0…20 mA, R
L
< 500 ohm
AO1 1
AGND 2
Motor current 0…20 mA, R
L
< 500 ohm
AO2 3
AGND 4
External power input XPOW
24 V DC, 2.05 A
Two supplies can be connected for redundancy.
+24VI 1
GND 2
+24VI 3
GND 4
Safety functions module connection X12
Control panel connection X13
Memory unit connection X205
Fault
To inverter modules
Notes:
The wire size accepted by all screw terminals (for both stranded and solid wire) is 0.5 …
2.5 mm
2
(24…12 AWG). The torque is 0.5 N·m (5 lbf·in).
1)
See section Drive-to-drive link (XD2D) (page 135) .
2)
See chapter The Safe torque off function (page 253) .
Control units of the drive 133