Zontes ZT350-GK 2022, Руководство по обслуживанию

Страница: 49 / 94

7-FRONT FORK COMPONENT
48
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1244300-023000 ZT310 rubber buckle (50mm) 1
2 1154100-011000 ZT250-R clutch cable 1
3 1244200-046000 ZT310-V clutch line sheath 1
4 1244300-042000 ZT310 rubber buckle (double buckle type)
1
Fig.2 FRONT FORK
COMPONENT
light height adjustment,Replacement clutch cable
PROCEDURE:
●
Light height adjustment
The rider sits on the bike and straightens the bike. Another person inserts a PH2 type Phillips screwdriver (diameter 6mm)
into the hole near the lower link plate of the car,the arrows are inserted backwards as shown in Figure "A" and "B", aligns
the adjusting bolt, rotates clockwise to increase, and counterclockwise to decrease the beam height.
●
Remove the cluch cable
First untie the thread buckle
⑴
and wire buckle on the right side of the frame buckle
⑷
.Use 14# an open-end wrench to
loosen the nuts
②
and
③
; fix the adjusting screw
①
, rotate the nut
②
up to the top of the thread of the adjusting screw, and
screw the nut
③
to the bottom to completely separate from the thread. Separate the clutch wire core connector from the
bracket
⑤
, close the nut
③
to the black sheath with one hand, and remove the adjustment screw
①
from the bracket
④
with one hand.
First, the protective rubber sleeve
⑶
is retracted to the elbow
⑧
and the nut
⑥
is loosened with the pliers; the nut
⑥
and
the adjusting screw
⑦
are rotated to the same position as the groove on the rocker arm, and remove the cable from the
rocker arm seat.
Remove the clutch cable.
Remove the protective sleeve
⑶
from the clutch cable
⑵
.
●
Install the clutch line
Put protective rubber sleeve
⑶
into clutch elbow.
After inserting the clutch line joint into the rocker arm, screw the nut
⑥
and the adjusting screw
⑦
to the groove on the
rocker arm.
Assemble the clutch cable into place according to the original alignment.
Rotate the nut
②
up to the top of the thread of the adjusting screw, and screw the nut
③
to the bottom to completely
separate from the thread.
Take the nut
③
close to the black sheath with one hand and insert the adjustment screw
①
into the bracket
④
with one
hand.
Insert the clutch core connector into the hole of the bracket
⑤
.
Initially position the nut
②
first, adjust the free stroke adjustment in the clutch cable adjustment, and then lock the nut
③
.
Finally, reset the protective rubber sleeve
⑶
.
CAUTION:
●
Light height adjustment should be noted as follows:
Too low or too high light levels can affect safe driving. The height of the lights should be properly adjusted according to
whether there are changes in the weight of the occupants and the driver.
It is forbidden to adjust the light height during riding. It is advisable to adjust the road with a smooth road surface and a
straight line distance of about 150 meters without affecting traffic safety at night.
●
The motorcycle support should be fixed during disassembly to prevent accidents caused by incline.
●
Before replacing the clutch line, it is necessary to disassemble the seat cushion, fuel tank, liner, side cover, etc.