Zontes ZT350-GK 2022, Руководство по обслуживанию

Страница: 88 / 94

11-REAR COVER COMPONENT
87
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1274300-052000 ZT350
－
GK rear mud board bracket 1
2 1251100-101000 Non-standard bolt M6×12 (304 stainless steel) 1
3 1174100-002000 ZT250
－
S rear reflector 1
4 1221200-068000 KD150
－
G1 rear license plate bracket 1
5 1251100-102000 Non-standard bolt M6×16
（
304 stainless steel
）
3
6 1274100-057095 Flanging bushing φ6.2×φ8.4×3.5
＋
φ14×1.5 3
7 1244100-052000 Buffer rubber of flanging bushing
（
φ8.5×φ14×1
）
3
8 1244100-006000 ZT250
－
S rear liceness rubber buffer 1
9 1221200-115000 KD150-G1 turn light decorative cover (set) 2
10 1170300-065000 HJ125
－
K rear left turn signal light 1
11 1170300-066000 HJ125
－
K rear right turn signal light 1
12 1224300-031000 ZT350
－
GK rear mud board
1
13 1251300-063093 Plywood M6×11×15
（
color zinc
）
1
14 1174200-021000 ZT310-X Liensed lights 1
15 1224300-032000 ZT350
－
GK rear license plate cover 1
PROCEDURE:
●
Rear license plate bracket
Remove 3 bolts (5) with 4# hexagon socket, remove flanging bushing (6) and buffer rubber (7), and remove rear license
plate support (4) from rear mud plate support (1). Pull out the buffer (8) from the license plate support (5).
●
Rear reflector
Use a 10# ring wrench to remove the nut
①
and gasket
②
on the rear reflector and remove the rear reflector.
●
Rear mudboard support
Remove the bolt (2) at the bottom with 4# hexagon socket. Take out the rear mudboard support (1) from the rear
mudboard hole.
●
Rear turn signal lamp assembly
Grasp the rear right turn signal light (11), remove the nut
③
of the steering lamp with 17# ring wrench, take out the spring
washer
④
and gasket
⑤
, and remove the rear right turn signal light.
Use a cross screwdriver to remove the two self tapping screws
③
from the steering lamp trim cover set, and separate the
front and rear shells of the trim cover.
Remove the rear left turn signal light (10) and the trim cover (9) according to the above steps.
●
Rear license plate lamp
Remove the 3 self tapping screws of the rear license plate lamp with a cross screwdriver, and remove the rear license plate
lamp (14) and the cover plate (13).
Remove the clamp nut
⒀
from the rear mud plate (12).
CAUTION
：
●
Never pull the cable directly.
Fig.8 REAR COVER
COMPONENT
Rear mud board component 2