Zontes ZT350-GK 2022, Руководство по обслуживанию

Страница: 84 / 94

11-REAR COVER COMPONENT
83
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1251100-101000 Non-standard bolt M6×12 (304 stainless steel) 2
3 1251100-102000 Non-standard bolt M6×16
（
304 stainless steel
）
2
4 1274100-057095 Flanging bushing φ6.2×φ8.4×3.5
＋
φ14×1.5 2
5 1244100-052000 Buffer rubber of flanging bushing
（
φ8.5×φ14×1
）
2
6 1274300-035000 ZT350
－
GK three generation PKE bracket
1
7 1251200-050094
Non-standard cross tapping screws ST3.9×12 (black zinc)
2
8 1184300-005000 ZT350 non electric induction antenna 1
PROCEDURE:
●
PKE
There is an anti release buckle on the back of the plug, which needs to be pulled out while pressing. Due to the
waterproof rubber ring in the plug, the resistance will be relatively large when pulling out. Pay attention not to
shake up and down to prevent damage to the main engine shell, but slightly shake left and right.
Remove the two bolts (1) with 4# hexagon socket and pull out the fuse box
①
upward to facilitate the removal
of PKE host assembly.
Remove two bolts (3) with 4# hexagon socket, remove bushing (4) and buffer rubber (5), and separate PKE
support (6) from PKE host (2).
●
Induction antenna
Remove the two screws (7) with a cross screwdriver, pull out the induction antenna (8) and then pull out the
plug. Whether there is an electric induction mark on the back of the electrical device box.
CAUTION
：
●
Never pull the cable directly.
●
When assembling self-tapping screws, it must be perpendicular tomounting surface, otherwise it will
bedamaged,and the torque should not be too large.
Fig.4 REAR COVER
COMPONENT
PKE component
2 1184300-024100 2.5 generation PKE assembly(including induction key) 1