Zontes ZT350-GK 2022, Руководство по обслуживанию

Страница: 43 / 94

6-COOLING SYSTEM COMPONENT
42
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1274200-090000 ZT310 water pipe clamp(φ26) 2
2 1244300-003000 ZT350
－
GK engine outlet pipe
1
3 1274200-091000 ZT310 water pipe clamp(φ27) 1
4 1274200-089000 ZT310 water pipe clamp(φ22) 2
5 1244300-004000 ZT350
－
GK small circulation water pipe
1
6 1274200-041000 ZT310 water pipe clamp (φ26) 3
7 1244300-005000 ZT350
－
GK engine water inlet pipe
1
8 1244200-012000 ZT310
－
R water pipe of engine 1
10 1251100-061093 M6×22 Hex flang bolt thread level 8.8 (color zinc) 1
11 1244200-139000 ZT310 rubber buckle (120mm) 1
Fig.9 COOLING SYSTEM
COMPONENT
Main water tank component 1
PROCEDURE:
●
Main water tank assembly
Unplug the fan plug
①
from the fan plug holder on the guard bar on the right side of the vehicle, and untie the
rubber wire buckle
⑾
.
After wearing waterproof gloves, clamp the water outlet pipe
⑵
of the left water tank with pliers, connect the
hoop
⑴
at the engine, remove the anti detachment boss upward, loosen the hoop
⑴
, pull out the water outlet pipe
⑵
, remove the hoop
⑴
, and remove one bolt (9) fixing the water tank on the left with 8# sleeve.
Remove the right holding hoop
⑷
with pliers, pull out the small circulating water pipe
⑸
, and remove the holding
hoop
⑷
.
Loosen the bolt
②
on the clamp
⑹
in the direction indicated by the arrow with a slotted screwdriver, move the
clamp (6) to the inside of the water pipe, pull out the water inlet pipe
⑺
, and connect one end of the engine and
the water outlet pipe
⑻
. Remove three clamps
⑹
).
Hold the water tank with one hand,and remove one bolt
⑼
and one bolt
⑽
on the right side with other hand with
8# sleeve. Then remove the main water tank component.
CAUTION:
●
Motorcycle should be well supported.Manipulation should start after the engine is completely cooled down.
●
Manipulation should start after the engine is completely cooled down.
●
Cooling liquid is toxic. Avoid strictly eye or skin contact.
●
Do not disassemble the hoop with too strong force. If not, it will cause permanent deformation and lose
elasticity, which will lead to leakage of cooling liquid.
●
When reassembling, be careful that the clamps and hoops should be prevented from loosening on the inside of
the boss.
9 1251100-070093 M6×30 flange full thread bolt(graped
9.8/environmental color)
2 12±1.5N.m