Zontes ZT350-GK 2022, Руководство по обслуживанию

Страница: 70 / 94

7-FRONT FORK COMPONENT
69
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1251513-013000 Disc brake pipe copper washer φ 15× φ 10.2 × 1.5 4
2 1251112-001093 M6×16 Hexagon flange bolts (color zinc) 2
3 1251100-101000 Non-standard bolt M6×12 (304 stainless steel) 1
4 1251100-102000 Non-standard bolt M6×16(304 stainless steel) 3
5 1224200-003000 ZT310-Z Rear disc brake pipe clamp 2
6 1224100-044000 Wheel speed sensor clamp 2
7 1181200-118000 Wheel speed sensor
（
A
）
1
8 1251100-112000 Disc brake pipe bolt M10×1-22 1
PROCEDURE:
●
RMC-HU
Find and unplug the brake switch cable plug.
Refer to the steps of "Right footrest component-1" and "Right footrest component-2" take off the rear brake main pump.
After wearing the waterproof gloves, remove the brake fluid by referring to the procedure of adding the brakefluid of the
rear brake master pump. Use a 14# open end wrench to loosen the brake switch nut. Remove the copper washer
⑶
and the
RMC-HU oil tubing.
●
Wheel speed sensor
First remove the rear section of the muffler by referring to the steps of removing the "muffler", find the cable connector of
the wheel speed sensor
⑺
and unplug it.Remove the two wheel speed sensor clamps
⑹
.
Pull out the sensor wire from the two disc brake oil pipe clamps
⑸
.
Remove one bolt
⑷
at the caliper with 4# inner hexagon socket, pull off the exhaust rubber cap and remove the sensor
wire.
●
Rear disc brake caliper
Refer to the steps of removing the rear wheel assembly in the front, remove the rear axle nut and the right chain adjuster,
and then retract the rear axle to the left to remove the rear disc brake caliper assembly. Put the rear axle, right chain adjuster
and rear axle nut back into the rear fork.
●
RC-HU
Place the oil pan under the rear disc brake caliper.
After wearing the waterproof gloves, remove the bolts
⑻
with a 12# sleeve; remove the copper washers
⑴
. If you need to
replace the RC-HU tubing, it is recommended to replace the two copper washers
⑴
at the same time; the bolts
⑻
can be
replaced if they are not damaged.
CAUTION:
●
The precautions for brake fluid are described in the previous section.
●
It is recommended to replace two copper washers at the same time when replacing the oil pipe, rear brakeswitch wire or
disc brake main pump.
●
The rear brake switch line is prohibited from rotating the rubber cap at the arrow indication. Replace thisswitch wire. Be
careful not to wrap the cable around the tool.
Fig.23 FRONT FORK
COMPONENT
ABS brake system-A 4