Zontes ZT350-GK 2022, Руководство по обслуживанию

Страница: 48 / 94

7-FRONT FORK COMPONENT
47
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1154300-002000 ZT350-GK throttle refueling line 1
2 1154300-003000 ZT350-GK throttle return line 1
3 1154100-011000 ZT250-R clutch cable 1
4 1244200-046000 ZT310-V clutch line sheath 1
Fig.1 FRONT FORK
COMPONENT
Throttle/clutch cable clearance adjustmen
PROCEDURE:
●
Throttle cable
Fix the adjusting screw
②
with 8# open-ended wrench, and then loosen the lock nut
①
on the accelerator oil
filling line
⑴
or oil return line
⑵
with 10# open-ended wrench. Turn the adjusting screw
②
to adjust the
clearance to 2 ~ 4mm. Lock the nut
①
after adjustment.
●
Clutch cable
Fine adjustment:
Lift the protective rubber sleeve
⑷
on the clutch rocker arm to the elbow of the clutch cable
⑶
, loosen the nut
③
with pliers, rotate the adjustment screw
④
, finally lock the nut
③
, and then reset the dust jacket. After
adjusting, pay attention to the nut
③
, the adjustment screw
④
and the groove of the rocker seat should be
staggered to prevent the cable from coming out.
Big adjustment:
If fine adjustment cannot be achieved, using 14# open spanner loosen the nuts
⑥
, rotate the adjustment screw
⑤
, and finally tighten the nuts
⑥
.
CAUTION:
●
The motorcycle support should be fixed during disassembly to prevent accidents caused by incline.
●
Throttle line adjustment should be noted as follows:
After adjustment, ensure that the throttle can be reset automatically. It is forbidden to increase the idle speed of
the engine due to adjustment of the cable.
The engine idle speed rise cannot occur in the direction of rotation.
Checking the engine idle speed should be performed under the condition of a heat engine and should be at 1500
to 1700 rpm.
●
The clutch adjustment should be noted as follows:
Excessive free travel can cause wear and malfunction of the clutch and gearshift mechanism.
After adjustment, be sure to stagger the nut, adjusting screw, and slot on the rocker arm to a certain position to
prevent the cable from coming out of the slot.