Zontes ZT350-GK 2022, Руководство по обслуживанию

Страница: 69 / 94

7-FRONT FORK COMPONENT
68
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1244300-019000 Caliper bleed screw rubber cap 1
2 1251100-308000 Disc brake exhaust screw M6 1
3 1251513-013000 Disc brake pipe copper washer φ 15× φ 10.2 × 1.5 2
5 1224100-044000 Wheel speed sensor clamp 3
7 1181200-118000 Wheel speed sensor
（
A
）
1
8
1251100-101000
Non-standard bolt M6×12 (304 stainless steel) 1
9 1224300-093000 Reverse buckle Velcro strap
（
20×150mm
）
1
10 1100100-847000 Double hole (Φ7) clamp 2
11
1224300-026000 ZT350
－
GK double groove pipe clamp (φ10) 1
12 1251300-063093 Plywood M6×11×15(color zinc) 1
13 1251100-101000 Non-standard bolt M6×12 (304 stainless steel) 2
14 1224300-068000 ZT350
－
GK head wiring box
1
15
1251100-061093 M6×22 Hex flang bolt thread level 8.8 (color zinc)
1
Fig.22 FRONT FORK
COMPONENT
ABS brake system-A 3
4 1251100-303093 GB70.1 Inner hexagon bolt M10×1.5×60 (level
10.9/environmental color zinc)
2
1251100-307000 Disc brake pipe bolt M10×1×22
（
threaded hole with
exhaust
）
1
PROCEDURE:
●
Drain the brake fluid
Place the oil pan under the front disc brake caliper.
First uncover the screw rubber cap
⑴
, wear waterproof gloves, then remove the bolt
⑵
with 8# ring wrench, remove the
bolt
⑹
with 14# ring wrench, and remove the copper washer
⑶
.
Remove two bolts
⑷
with 8# inner hexagon socket to remove the front disc brake caliper from the front shock absorber.
First take out the wheel speed sensor
⑺
from the wire clamp
⑸
, untie the ribbon
⑼
, then remove the bolt
⑶
with 4#
hexagon socket, and remove the wheel speed sensor
⑺
from the front disc brake caliper. Tidy up the wheel speed sensor
wires.
Remove the water tank trim cover assembly according to the steps of removing the water tank; Remove the oil tank
according to the steps of removing the oil tank. Remove the bolt
⒀
with 4# inner hexagon socket and remove the wiring
box
⒁
. Remove bolt
⒂
with 8# sleeve. Then remove the FC-HU oil pipe.
CAUTION:
●
The muffler and engine must be completely cooled before disassembly. The disassembly and assembly operation shall be
carried out after the horizontal support of the vehicle is fixed.
●
Refer to the previous description for relevant precautions of brake fluid.
●
When replacing the oil pipe, it is recommended to replace two copper washers
⑶
at the same time. If the bolt
⑹
is not
damaged, it can not be replaced.
6