Zontes ZT350-GK 2022, Руководство по обслуживанию

Страница: 87 / 94

11-REAR COVER COMPONENT
86
CHK
ADJ
NO. PART NO. PART NAME QTY CAUTION
1 1251100-101000 Non-standard bolt M6×12 (304 stainless steel) 4
2 1244300-023000 ZT310 rubber buckle (50mm) 1
3 1224200-205000 ZT310 electronic cushion lock block 1
4 1274100-058000 ZT310 Electric seat lock 1
5 1251100-102000 Non-standard bolt M6×16
（
304 stainless steel
）
2
6 1274100-057095 Flanging bushing φ6.2×φ8.4×3.5
＋
φ14×1.5 2
7 1244100-052000 Buffer rubber of flanging bushing
（
φ8.5×φ14×1
）
2
8 1251300-063093 Plywood M6×11×15
（
color zinc
）
2
9 1171200-060000 KD150
－
G1 Rear Taillight
1
Fig.7 REAR COVER
COMPONENT
Rear mud board component 1
PROCEDURE:
●
Rear mudboard assembly
First pull up the anti falling card of the rear taillight plug
①
as indicated by the arrow in Figure 1, and then pull
it out.
Pull out the rear license lamp plug
②
, cushion lock plug
③
and rear steering lamp plug
④
at the left taillight
plug clamp.
Remove the rear mud board assembly from the vehicle. Be careful not to pull the cable forcibly. Pay attention
not to press the cable during reassembly.
Take off the line buckle (2).
●
Cushion lock
After grasping the cushion lock firmly, remove the bolts (1) with 4# hexagon socket, remove the guide block
(3) and then remove the cushion lock (4).
●
Rear taillight
Remove the bottom bolt (1) with 4# hexagon socket.
Remove the upper two bolts (5) and remove the bushing (6) and buffer rubber (7).
Remove the rear taillight assembly and remove two clamp nuts (8) from the rear taillight (9).
CAUTION
：
●
Never pull the cable directly.
●
The parts should be protected during discomponent to prevent scratching.
●
Pay attention to the lamp connector, do not insert the wrong, the left turn signal is green + orange; right turn
signal is green + blue.