For not all inputs are available at the same time, for every counter you may define the
input assignment via the parameterization for the following input signals:
n
Counter
x
(A)
–
Pulse input for counter signal respectively track A of an encoder for 1-, 2- or 4-fold
evaluation.
n
Counter
x
(B)
–
Direction signal respectively track B of the encoder. Via the parameterization you
may invert the direction signal.
n
Gate 3
–
Via this input you can if parameterized open the HW gate of
Counter 3
with edge
0-1 and start counting.
n
Latch 3
–
Via this input via edge 0-1 the current counter value of
Counter 3
is stored in a
memory that you may read if needed.
5.6.2.2
Counter outputs
X5
Function
Type
Description
1
Sys DC 24V
I
1L+: DC 24V for electronic section supply
2
Sys 0V
I
1M: GND for electronic section supply
6
DO 0
O
+0.0: Output channel counter 0
7
DO 1
O
+0.1: Output channel counter 1
8
DO 2
O
+0.2: Output channel counter 2
9
DO 3
O
+0.3: Output channel counter 3
18
DC 24V
I
2L+: DC 24V power section supply for on-board counter
19
0 V
I
2M: GND power section supply for on-board counter
20
DC 24V
I
3L+: DC 24V SLIO bus power section supply
21
0 V
I
3M: GND SLIO bus power section supply
Every counter has an assigned output channel. For each counter you can specify the
behavior of the counter output via the parametrization with
‘Characteristics of the output’
and
‘Pulse duration’
Chap. 5.6.4.3 ‘Counter’ page 131
X5: Connector
Output channel Counter
x
VIPA System SLIO
Deployment I/O periphery
Counting > Wiring
HB300 | CPU | 013-CCF0R00 | en | 19-30
129