Wood-mizer LT15M2 D10, Руководство пользователя, Страница: 50 / 105

Setup & Operation
Sawmill Setup
3
3-2 15doc080213 Setup & Operation

Cam engaging the limit switch and/or stop bolt -
See page 3 - 9.
The following setup procedure should be performed whenever the sawmill is moved or
reassembled. If sawing problems occur and misalignment is suspected, see
SECTION 6
for
complete alignment instructions.
1. Adjust the frame legs so the sawmill appears level. If sawmill is on soft ground, use shims under
the legs if necessary.
2. Run a string from the front bed rail to the rear bed rail near the operator’s side of the frame. Place
identical spacers between the string and the front and rear bed rails. Measure the distance
between the string and the other bed rails. Adjust the frame legs until all bed rails measure the
same distance from the string.
3. Loosen the auxiliary bed rail bolts and adjust the rail so it is the same distance from the string as
the main bed rails. Retighten the bolts.
See Figure 3-1.
4. Repeat the bed rail adjustment with the string at the other side of the sawmill frame.
5. Install a blade (
See Section 3.2
through
Section 3.4
) and move the saw carriage until the blade is
positioned over the front bed rail.
6. The blade guide rollers should not touch and deflect the blade and the blade guide arm should be
adjusted all the way out, away from the other blade guide.
FIG. 3-1
String across
bed rails
Equal height
object
Equal height
object
Measure distance
between string
and bed rails
150115c
Measure distance
between string
and bed rails
String across
bed rails