Alignment
Horizontal Tilt Adjustment
Alignment
15doc080213
6-13
6
6.10 Horizontal Tilt Adjustment
1.
Finally, both blade guides must be tilted horizontally. Adjust the blade guide arm half way in.
See Figure 6-14.
2.
Place Blade Guide Alignment Tool against the face of the outer blade guide roller.
3.
Center the tool on the roller and measure between the back edge of the blade and the ruler at the
end closest to the inner blade guide ("B").
4.
Measure between the back edge of the blade and the other end of the ruler ("A").
5.
The roller should be parallel to the blade (A=B) or tilted slightly to the left (A=B-1/4" [6 mm]).
6.
Use the side set screws to adjust the horizontal tilt of the roller.
7.
Repeat Steps 3 - 7 for the inner blade guide roller.
NOTE:
Once the blade guides have been adjusted, any cutting variances are most likely caused
by the blade.
See Blade Handbook, Form #600.
6.11 Side Supports
Logs and boards are clamped against the side supports when sawing. The sides supports must be
square to the bed to ensure square lumber.
1.
Place a flat board across the bed rails.
FIG. 6-14
50cm (19.7")
Содержание LT15M2 D10
Страница 1: ...Table of Contents Section Page Table of Contents SW 07doc0802131...
Страница 2: ......