WEG CFW-11 Series, Руководство по программированию

Страница: 136 / 307

Vector Control
11-18
11
7. Adjust P0161 and P0162 according to the response type presented in the Figure 11.4 on page 11-17 .
a) Reduce the proportional gain (P0161) and/or increase the integral gain (P0162).
b) Speed regulator is optimized.
c) Increase the proportional gain and/or reduce the integral gain.
In the sensorless vector control mode, the maximum typical values for proportional gain P0161 must not be greater
than 9.0. If that happens, strange behaviors of the motor may be observed, such as: motor remains still or turns at low
speed, although the output current is different from zero. It is recommended to reduce the value adjusted in P0161
until the motor behavior is correct.
P0163 – Local Reference Offset
P0164 – Remote Reference Offset
Adjustable
Range: -999 to 999 Factory
Setting: 0
Properties: PM and Vector
Access groups
via HMI: 01 PARAMETER GROUPS
29 Vector Control
90 Speed Regulator
Description:
An offset of the analog input AIx may be occasionally adjusted. The value 999 is equivalent to a value of 0.1219
pu. Refer to the
Figure 13.8 on page 13-33 .
P0165 – Speed Filter
Adjustable
Range: 0.012 to 1.000 s Factory
Setting: 0.012 s
Properties: PM and Vector
Access groups
via HMI: 01 PARAMETER GROUPS
29 Vector Control
90 Speed Regulator
Description:
It sets the time constant of the motor speed filter either measured by the encoder when P0202 = 4, or estimated
when P0202 = 3. Refer to the
Figure 11.1 on page 11-2 or Figure 11.2 on page 11-4 .
NOTE!
Generally, this parameter must not be changed. The increment in its value turns the system response slower.