Vodavi Starplus Triad-S, Руководство пользователя

Страница: 183 / 512

Last Number Redial 2-157
Chapter 2 - Features and Operation
2. Press [ ✳ ] to scroll through the keyset modes.
3. Press [#] to scroll through the baud rates.
4. Press the HOLD button to save the desired entries.
℡
ELECTRONIC TELEPHONE
Not applicable
SINGLE LINE TELEPHONE
Not applicable
Conditions
»
Telephone must be in AT command mode to process AT commands.
»
CTI information is still sent out the RS-232 port in AT command mode.
»
The ATD command is always accepted by the telephone while it is in the AT command
mode. ATHX is accepted only if enabled.
»
ATZ is always enabled if station is in the ATD or ATH command mode.
»
ATD accepts W to indicate a pause command (ATDT9W9982200).
»
ATH or ATH0 causes an on hook event. ATH1 must be specified to go off hook.
»
AT or ATZX (X = 0 or 1) is the modem reset/initialize command. When these commands
are sent to the keyset, it returns OK in ASCII format.
»
Only one station at a time can be programmed when using a flexible station number.
»
When in Flash 51 programming, if you press HOLD without specifying a flexible number
to be programmed, you will get the station that is in port/station 100.
Last Number Redial
Description
The Last Number Redial (LNR) feature permits the automatic redialing of the last telephone
number dialed on an outside line. Up to 24-digits can be stored. Outside line selection of the
same line used is automatic.
Operation
1. Press the SPEED button.
2. Press [#]. The last number dialed over an outside line is automatically redialed.
The system automatically selects the original line used to place the call and redials
the number.
If that line is busy, the system automatically selects another line from the same group
and redials the number.
If no lines are available in the same group, the station receives busy tone and can
queue for a line.
If the station user preselects a line before activating LNR, the preselection overrides
the line that was used originally.