3. Installation
D-307083 PowerMaster-360R Installer's Guide
9
3.2 Installing the PowerMaster-360R battery and cables
1)
To open the panel, use a coin or 3 mm flathead
screwdriver to rotate the lock by 90 degrees counter
clockwise to the unlocked position.
2)
Use minimal force to pull the panel from the base.
3)
Use the screws and anchors provided to fasten the
base to the wall.
Warning:
The tamper screw is mandatory; use the
remaining screws to secure the base.
4)
To install the battery in the panel, complete the following steps:
a)
To prevent mechanical damage, insert the battery carefully into the slot in the direction of the arrow,
see figure (a) for details.
b)
Press downwards and place under the clip, see figure (b) for details.
c)
Run the wire along the channel and connect the battery cable plug into the battery socket, see figure
(c) for details.
a.
a.
a.
b.
c.
