4. Programming
D-307083 PowerMaster-360R Installer's Guide
21
Step 9
Step 10
Step 11
Enter Device Settings
Menu
[9]
Configure Device
Parameters
[10]
Continue or End
➯
Z10:DEV SETTINGS
Refer to device
datasheet in the device
Installation Instructions
for specific configuration
instructions.
To continue –
See
[11]
- Configuring New Devices
Location (name) setting:
[1]
To review or change the
Location
(name) setting, press the
button, otherwise scroll to the next
option.
[2]
To change the Location name, enter the menu and select the name from the
Location List
below. You can
assign additional custom names using the
06.CUSTOM NAMES
option in the Installer Mode menu. See
section 4.8.
Note:
As a shortcut, press the 2 digit serial No. of the Custom Location, which takes you directly to its menu.
Zone Type setting:
[3]
To review or change the
Zone Type
setting, press the
button, otherwise scroll to the next option.
[4]
The zone type determines how the system handles signals sent from the device. Press
and select a
suitable zone type. The list of available
Zone Types
and the explanation for each zone type is provided below.
Note:
As a shortcut, press the 2 digit serial No. of the
Zone Type
shown in the Location List below, which
takes you directly to its menu.
Chime setting:
[5]
All zones are set to
chime OFF
by default. To configure the device to cause the panel to sound (when disarmed)
a
Chime
melody when tripped, press the
button, otherwise scroll to the next option.
[6]
Select between
Chime OFF
,
melody-chime
and
zone name-chime
. In melody chime the control panel
sounds a chime melody when the sensor is tripped. In zone name-chime the control panel sounds the zone
name when the sensor is tripped. The chime operates during the Disarm mode only.
Partitions setting:
Note:
The PARTITIONS menu appears only if Partitions is enabled in the control panel (see section 4.13).
[7]
When entering the menu, the display shows the default Partition selection (marked with
).
[8]
Use the keypad keys
,
,
to assign partitions to the device.
Device Configuration:
[9]
To review or change the
Device Configuration
(settings)
, press the
button, otherwise scroll to the
next option – see
[11].
[10]
To configure the device parameters, refer to its corresponding device datasheet in the device Installation
Instructions. The defaults of the device parameters can be also configured as explained in section 4.4.7.
[11]
After completing the configuration of the device, the wizard brings you to the
Next Step
menu with the
following 3 options:
NEXT Device
to enroll the next device.
MODIFY Same Dev.
reverts to Step 1 (
LOCATION
) to allow you to perform additional changes to the device,
if needed.
EXIT Enrollment
exits the enrollment procedure and returns to Step 1 bringing you back to the
ADD NEW
DEVICES
menu.
Location List
No.
Location
Name
No. Location Name
No. Location Name
No. Location Name
01
Attic
09
Dining Room
17
Hall
25
Utility Room*
02
Back door
10
Downstairs
18
Kitchen
*
26
Yard
03
Basement
11
Emergency
19
Wired PSU
*
27
Custom1
04
Bathroom
12
Fire
20
Wired Siren*
28
Custom2
