Vigilantplant TDLS8000, Руководство пользователя

Страница: 66 / 320

<3. Installation, Wiring, Optical Axis Adjustment, and Piping>
3-21
IM 11Y01D01-01EN
l
Wiring procedure
• For the cable type to use, see “
n
Types of Wiring and Cabling”.
• Be sure to ground the cable shield on the TDLS8000 side and on the other side.
• The output rating is +24 V DC 500 mA max. Check that the solenoid valves that you want to
use do not exceed these values before connecting them.
CAUTION
Do not short the SV terminals when the solenoid valve control output is on. Doing so will cause
the internal protection fuse to melt, preventing output. If this happens, the component needs to be
replaced.
3.2.8 Connecting an Ethernet Cable
NOTE
Reception of numerous invalid packets may affect the TDLS8000 functionality.
When connecting the TDLS8000 to a network, we recommended that you manage the network
appropriately.
If you want to connect the TDLS8000 to an YH8000 (HMI unit) through an Ethernet hub or to an
external device through Modbus/TCP communication, you will need to use an Ethernet cable.
The Ethernet cable connector must be crimped during the TDLS8000 installation.
NOTE
• Before crimping the Ethernet connector, pass the cable through cable gland. After crimping
the Ethernet connector, the connector cannot be passed through the cable glands.
• Be careful of the cable gland orientation. The end with the screw section of the cable gland
is the connector end.
• Use an eight-core CAT 5e shielded cable for the Ethernet cable.
Use a braided wire type shield. If the shield is a metallic foil type, the shield may not be
properly grounded.
Use a cable with straight wiring.
• Use a cable gland with a cable diameter specification that matches the outer diameter of the
Ethernet cable.
3rd Edition: Jun. 10, 2016-00