Vigilantplant TDLS8000, Руководство пользователя

Страница: 131 / 320

<6. Configuration>
6-16
IM 11Y01D01-01EN
A B C D E
TDLS8000
LU or SCU
A1 B C D E
TDLS8000
LU or SCU
A2
General purpose and zone 2
zone 1 model
Insertion
tube
Window of
Alignment flange
Window of Isolation flange
Window for
exp. construction
Window of
Alignment flange
Process
Window of Isolation flange
Insertion
Tube
Non-process optical prth length
Non-Process Optical Prth Length
when with insertion tube
Optics
Module
Non-process optical prth length
Non-Process Optical Prth Length
when with insertion tube
Process
Optics
Module
Figure 6.2 Definitions of non-process optical path length
6.10.1 Non-process Optical Path Length
Set the optical path length of the non-process area.
Setup menu path:
[HART] “Detailed setup>>Analysis>>Non process param>>No-prcs OPL”
[YH8000] “Configuration>>Analysis>>Non-Process Parameters>>Path Length”
The length of the non-process optical path is the total of the lengths of the laser unit (LU) side and
sensor control unit (SCU) side. Calculate the length according to the corresponding procedure
below because it differs depending on the installation conditions.
l
Non-process optical path length
The total target area differs depending on the installation conditions as shown in Table 6.1.
Furthermore, the length of each area of the total differs depending on the model name and code
as shown in Table 6.2 to Table 6.5. Use the values in Table 6.2 to Table 6.6 to calculate the non-
process optical path length using the corresponding calculation formula in Table 6.1.
3rd Edition: Jun. 10, 2016-00