Vicruns VD500 Series, Инструкция по эксплуатации

Страница: 213 / 216

VD500 Series Inverter User Manual Appendix B Incremental PG Card
- 209 -
Appendix B Incremental PG Card
VD500 series inverter support close-loop vector control, incremental PG card, the model is:
V5GT005PG3Y0.
COM OA+ OB+ OA
12V OA- OB OB-
PE
LED
MFI
J6
CPU
V
A A A
V V
J15 J3J4 J5 J14
J7
1.After dismantling the original
screw, then install and pull tight a
brass screw for the specification
of the M3*11.
2.Insert the expansion card J20
insert to extension seat of control
board J7 correctly.
3.Firstly, pull tight the screws that
removed previously, then fixed the
extension card.
485+ 485- 5/10V AI2 AO1 HDI1 DI2 T1/B T1/C
PE GND DI3 GND DI1 AO2 AI1
T1/A COM +24V OPEN DI4
DI5 COM HDO1 DO1 T2/A T2/C
A+ A- Z+ Z-
B+ B- GND 5V
S1 S2 S3 S4
Separate dial any of a set of dialswitch to
realize frequency division output: S1, S2, S3,
S4 corresponding 2,4,6,8,16 frequency
division
J7 J2
J4
Fig B-1 Incremental PG card and installation diagram
B.1 Introduction of V5GT005PG3Y0 Difference PG Card
1. You must use the incremental encoder (ABZ) of working power supply for 5V + / - 10% or 12V
+10%.
2. V5GT005PG3Y0 card as incremental encoder access Vicruns inverter adapters. Can be applied to
motor closed-loop vector control occasions.
3. At the same time, the card support open collector way encoder, at this point, terminals A -, B -, Z -
without wiring.
4. V5GT005PG3Y0 card terminal description:
Terminal Name: Function: Response Speed:
+5V, +12V, GND Encoder working power supply -
A+, A- Encoder A signal 0~300kHz
B+, B- Encoder B signal 0~300kHz
Z+, Z- Encoder Z signal 0~300kHz
PE Shielding terminal -