Vari RAPTOR Hydro, Инструкция по эксплуатации

Страница: 49 / 100

RAPTOR Hydro
TOOLS ACCESSORIES
Open-end spanner (wrench) 10 mm - 1x Petrol can, capacity 5 litres, HONDA (Ordering No. 4359)
Open-end spanner (wrench) 13 mm - 1x HONDA fuel stabilizer (Ordering No. 08CXZ-FSC-250)
Open-end spanner 15 mm, narrow - 1x Briggs & Stratton Fuel Fit™ fuel stabilizer (Ordering No. 992381)
12-point socket 15 mm, 16 mm - 1x VARI POWERMETER operating hours counter (Ordering No. 4227)
Bent ratchet handle 3/8“ Z-02 pin (Ordering No. 121001)
Spark plug spanner 16 mm (3/8“) - 1x
Table 36: Recommended Tools and Accessories
3.5.2 Travel Wheels
3.5.2.1 Tyre Pressure
For proper operation and to ensure a long service life of the travel wheels, especially the tyres, it is necessary to check the tyre pressure.
Perform the check before starting to work with the machine. Before parking the machine for a longer time, inflate the tyre to the MAX
value (see below). Keep the same pressure in the left and right wheels – the machine better holds a straight track.

Do not exceed the maximum tyre pressure – there is a risk of the tyre explosion!

If the pressure in the tyre is low, the inflation valve on the tube may get cut off.

MAX imum (recommended) tyre pressure: 25 PSI ( 172 kPa or 1.724 bar or 1.7 atm or 0.172 Mpa )

MIN imum 73 allowed tyre pressure: 18 PSI ( 124 kPa or 1.24 bar or 1.22 atm or 0.124 Mpa )
If there is a permanent tyre pressure leakage, make sure that there is no defect on the tyre tube – repair it if necessary.

If you are not sufficiently manually skilled, have the operations done by an authorized service centre.
3.5.3 Machine Lubrication

When working with lubricants, observe the basic hygiene regulations and observe the environmental protection
regulations and laws.
3.5.3.1 Engine Oil Change
Follow the instructions stated in the motor operating instructions. Shorten the change interval to one half, if you are to use your machine
in a dusty environment.
Either remove the oil with the professional oil-collecting equipment or with the JANETTE type syringe (with the capacity of 150 ml) – Fig.
15
on page
95 -
with the plastic hose on.

If you are not sufficiently manually skilled, have the operations done by an authorized service centre.
3.5.3.2 Gearbox Oil Change
Since replacement of the gearbox oil requires disassembling of some parts of the machine and special tools and preparations, you cannot
carry it out yourself. It is always necessary to have the authorized service centre do the work.
3.5.3.3 Lubrication Points
From a wide range of oils, any engine or gear oil or spray oil is suitable for lubrication. We recommend to use the so called white vaseline
spray; it penetrates well to apertures and does not lose lubricating properties for a long time. Sliding bearings require to be lubricated by a
lubricant with MoS and graphite admixture. However, its application usually requires the dismantling of the respective slide. Leave this work
to the authorized service.
73
If the tyre pressure is lower than the minimum, the tyre-casing structure will be damaged and the service life will be significantly reduced.
49
re
vi
ze
1
1/
20
17