Vari RAPTOR Hydro, Инструкция по эксплуатации

Страница: 41 / 100

RAPTOR Hydro

When using the machine on slippery surfaces (e.g. on the snow cover), always use quality winter footwear with an anti-skid
pattern. When the risk of falling down is imminent, do not hold on to the machine and do not try to stop it.

Never leave the engine running at full speed or idling for a long time when the attached work tool drive clutch and travel wheels
drive clutch are OFF! It can damage components of the drive mechanisms of the machine (such as clutch bearings, the v-belt,
belt pulleys, clutch pulley, etc.), which can lead to an unexpected accidental initiation of the drive of the attachments, or the
machine may be accidentally set in motion.

Information for the entity operating the machine based on the requirement of the Directive 2002/44/EC – exposure of employees
to vibrations:

With regard to the value of the declared A sound pressure level at the work station, it is necessary to use one's personal
protective equipment against noise, which is effective for the aforementioned noise level.

With respect to the declared values of vibrations transmitted to the operator’s hand and arm, it is necessary to adjust
the working procedures for this type of machine by specifying appropriate technological breaks to reduce vibration
exposure.

It is prohibited to work with the machine on any road of any class while the work tool is attached to the machine; the
perpendicular crossing of such roads is permissible in the places where it is specifically allowed.

Always turn OFF the engine and wait for the work tool to stop before performing any work in the close vicinity of the machine!
Before leaving the machine, always turn off the engine and secure it so that it cannot get accidentally turned on.

It is forbidden to remove any protective devices and covers from the machines.

Any repairs, adjustments, lubrication, and cleaning of the machine must be carried out when the machine is at a standstill and
its spark plug connector is disconnected.

When working with lubricants and cleaning the machine, observe the basic hygiene regulations and observe the environmental
protection regulations and laws.
3.2.2 Noise and Vibrations Levels
Description RAPTOR Hydro + RBS-700 + RMS-600
Declared acoustic pressure emission level A at the operator's site 57 L
pAd
87,0+4,0 [dB] 87,0 + 4,0 [dB]
Declared acoustic output level A 58 L
WA,d
103+4 [dB]
100+4 [dB]
Declared cumulative value of the acceleration of vibrations transmitted to the
operator’s hand-arm 59 a
hv,d
7,2+2,9 [m.s -2 ] 7,6+3,0 [m.s
-2 ]
Table 30: Measured Noise and Vibrations Levels
3.2.3 Safety Pictograms
The user is obliged to keep the pictograms on the machine in a legible state and, in case of any damage, ensure their replacement.
The pictograms and their position on the machine are shown at
Fig. 14 on page 95 .
57
per ČSN EN 12733+A1, Annex B and ČSN EN ISO 11201 : April 2010
58
per ČSN EN 12733+A1, Annex B and ČSN EN ISO 3744 2010
59
per ČSN EN 12733+A1, Annex C, par. C. 4.1.2
41
re
vi
ze
1
1/
20
17