Vanguard OHV V-Twin, Руководство пользователя

Страница: 62 / 191

2 LOCKED FOR PRINTING – SELECT SECT. NEEDED >
61
GASEOUS FUELED ENGINES
TROUBLESHOOTING GUIDE
Symptom Potential Cause Action
Plugged vent ports on the regulator.
Remove plastic shipping plugs.
Less than 11 inches of water
pressure at the inlet of the
secondary regulator.
Adjust the primary regulator output to 11
inches of water pressure.
If natural gas supply is lower than 11
inches of water, a different secondary
regulator may be required – consult OEM.
More than 14 inches of water
pressure at the inlet of the
secondary regulator under full load.
Adjust the primary regulator to achieve 11
inches of water pressure while under load.
Note: If pressure at inlet of secondary
regulator increases upon start-
ing the engine, check primary
regulator for holes or tears in
the diaphragm or dirt on the
inlet seat.
Plugged fuel filter.
Replace fuel filter.
Kinked or obstructed fuel hose. Remove the kink and/or replace the hose.
No or low fuel in tank. Refuel the tank.
Engine does not accelerate from
low speed or high speed or run
smoothly when loaded.
Propane tank is too small.
Appropriately size the fuel tank for the
engine horsepower and lowest ambient
temperature.
Fuel transfer solenoid in the wrong
position.
When the fuel solenoid is energized or if
the main mixture adjustment screw is
completely seated, the engine is
configured for propane gas (mixture too
lean for natural gas).
If the fuel solenoid is not energized, the
engine is configured for natural gas
(mixture too rich with propane).
Carburetor not adjusted properly
(natural gas only).
Readjust the mixture needles on the
carburetor.
Air leak in the fuel line from
secondary regulator to carburetor.
Tighten the clamps or replace the hose.
Holes, tears or damaged diaphragm
in secondary regulator.
Replace damaged part.
Debris on inlet needle of regulator.
Clean system of debris and add a fuel
filter.
Use liquid pipe sealant – do not use Teflon
tape.