7
130
Fig. 17
A
B
Replace Brushes
Three different brush end caps are used. Refer to
Fig. 18
for radial flat coil spring end caps.
Fig. 18
Refer to
Fig. 19
for radial compression spring end
caps.
Fig. 19
Refer to
Fig. 20
for axial compression spring end
caps and for the correct location of positive brushes
(1), negative brushes (2), brush leads and wire
routing. Note order of assembly for insulators,
washers and screws or nuts.
Fig. 20
Assemble End Cap
NOTE:
When all parts have been inspected,
lightly lubricate bearings in both end caps
with #20 oil.
Radial Flat Coil Brush Spring
1. Assemble armature to brush end cap before
installing brushes.
2. Install brush in holder.
3. Position coil spring over tab (1),
Fig. 21
.
4. While holding spring on tab, use a screwdriver
and bend spring clockwise and position over end
of brush.
5. Push spring down firmly over tab.
6. Repeat for remaining brushes.
Fig. 21
Radial Compression Brush Spring
End caps with radial compression type springs
require 4 brush retainers (1) to hold brushes clear of
armature commutator,
Fig. 22
.
Содержание OHV V-Twin
