4
LOCKED FOR PRINTING – SELECT SECT. NEEDED >
81
Fig. 20
11
12
13
14
15
11
Carburetor Service
Aisan Carburetor
Models 290700, 303700, 350700
(After 950930xx)
Check Throttle, Choke Shaft and Body For Wear
NOTE:
The measurement in Step 1 is taken with the
carburetor off of the intake manifold.
1. Lay carburetor on flat surface and check throttle
and choke shaft clearance (1) as shown,
Fig. 21
.
Fig. 21
Throttle shaft and choke shaft clearance must not
exceed
0.010” (0.25 mm)
.
NOTE:
The inspection in Step 2 is performed after
the carburetor has been disassembled.
2. Inspect throttle shaft and choke shaft for wear
(2),
Fig. 22
.
Fig. 22
Replace either shaft if worn.
Replace the carburetor if the body is worn or if either
shaft clearance
exceeds
0.010” (0.25 mm)
when a
new shaft is used.
Disassemble
1. Remove anti-afterfire solenoid (1) or bowl screw
(5) and washer (4),
Fig. 23
.
2. Remove float bowl (3). Discard bowl gasket (2).
Fig. 23
3. Remove float hinge pin (6), float and inlet
needle,
Fig. 24
.
CAUTION:
Float hinge pin is a press fit.
Use care when removing.
Содержание OHV V-Twin
