Vanguard OHV V-Twin, Руководство пользователя

Страница: 88 / 191

4 LOCKED FOR PRINTING – SELECT SECT. NEEDED >
87
NOTE: The top and bottom edges of the throttle
plate are beveled. Mark throttle plate before
removing to ensure reinstallation in the
original position.
9. Remove retainer (15).
10. Remove throttle shaft and spacer (19).
11. Remove seals (14) and foam seals (16).
Fig. 47
14
15
17
16
18
19
16
14
12. Remove two screws (20), choke plate (21),
shaft, seal (24) and washer (25), Fig. 48 .
CAUTION
•
Carburetor body has a detent ball (22) and
spring (23) that keeps tension on choke shaft.
Wear eye protection.
•
Use caution when removing shaft!
AVOID EYE INJURY!
Fig. 48
20
21
22
23
24
25
Remove Fuel Inlet Body and Seat
The fuel inlet body must be removed before the inlet
seat can be removed.
1. Use Screw #93029 (1) from Flywheel Puller,
#19165 . Thread screw into seat body 3 - 4 turns,
Fig. 49 . Remove the screw from the seat body.
Fig. 49

2. Install 1/4” x 20 Nut #92278 (2) and Washer
#224061 (3) from #19332 Tool Kit onto screw,
Fig. 50 .
3. Place a 1/4” drive 9 mm (3/8”) socket (4) over
seat body.
4. Install screw, washer and nut. Thread nut down
on washer.
5. Continue turning until seat body is removed.
Remove fuel inlet seat (5).
This completes the carburetor disassembly
procedure.
Fig. 50
„
ƒ
‚