Vanguard OHV V-Twin, Руководство пользователя

Страница: 96 / 191

4 LOCKED FOR PRINTING – SELECT SECT. NEEDED >
95
Fig. 76

‚
NOTE: The inspection in Step 2 is performed after
the carburetor has been disassembled.
2. Inspect throttle shaft and choke shaft for wear
(3), Fig. 77 . Replace if worn.
Fig. 77
ƒ
Replace either shaft if worn.
Replace the carburetor if the body is worn or if either
shaft clearance exceeds
0.010” (0.25 mm) when a
new shaft is used.
Disassemble
1. Remove four screws and upper body (1),
Fig. 78 . Do not damage emulsion tube (2) in
upper body.
Fig. 78

‚
2. Remove and discard gasket.
3. Remove float and inlet needle.
Fig. 79
If idle mixture screw is equipped with adjustment
limiter cap (9), use a pliers to remove it before
removing idle mixture screw (inset),
Fig. 80 .
4. Remove idle mixture screw (3) and spring (4),
Fig. 80 .
5. Remove anti-afterfire solenoid (8), if equipped,
or plug (7) and washer (6).
6. Remove fixed main jet (5) using Screwdriver,
#19062 .
Fig. 80
„
ƒ
‰
† ‡
ˆ
7. Remove pilot jet (10) using Screwdriver #19061 ,
Fig. 81 .
Fig. 81
Š