Vanguard OHV V-Twin, Руководство пользователя

Страница: 153 / 191

9
152
ENGINE BEARINGS
Mag Bearing – After 970430xx
Check
1. Check magneto bearing for damage. Check for
wear at several locations using plug gauge
#19219 (1) or appropriate measuring tools,
Fig. 5. If plug gauge is not available see reject
dimension in Section 13.
2. Replace bearing if damaged or worn.
Fig. 5

Remove
1. Remove the oil seal.
2. Insert Bushing Driver
#19450 (1) into bearing
from oil seal side, Fig. 6 .
3. Place a reference mark (2) on driver to indicate
proper depth when installing new bearing.
Fig. 6

‚
4. Place cylinder on Cylinder Support #19227 with
large opening facing bearing.
5. Press out bearing with bushing driver (1), Fig. 7 .
Install
1. Place cylinder on Cylinder Support #19227 with
large opening facing bearing, Fig. 7 .
2. Align oil holes in bearing with oil holes in cylinder.
3. Press in new bearing to correct depth with
bushing driver (1).
Fig. 7

4. Stake bearing in top notch (2) with 1/8” round
pin punch to prevent bearing from turning,
Fig. 8 .
Fig. 8
‚
5. Install new oil seal with sealing lips facing in. Use
Cylinder Support #19227 . Press oil seal until
flush with cylinder.
Mag Bearing – Before 970501xx
Check
1. Check magneto bearing for damage. Check for
wear at several locations using #19380 plug
gauge or appropriate measuring tools, Fig. 9. If
plug gauge is not available see reject dimension
in Section 13.
2. Replace bearing if damaged or worn.
Fig. 9
