Turnigy
TrackStar 10
th
W
aterproof
S
ensored ESC Manual
Transmitter Calibration:
Connect the ESC, battery and signal line, and then press the switch button for about 3 seconds, the blue LED
long bright solid, the ESC is into the transmitter calibration mode:
1.
Pu
sh
the transmitter stick to maximum forward position,
the
blue LED
will
flash
and then the red LED lights
will go
solid.
2.
Then push
the
throttle stick to max brake position, the red LED will
start
flashing
and then the blue and red
LED
lights.
3.
Return
the
throttle stick to neutral position, the red and blue LED
will
flash,
t
hen
a
long light for about 2
seconds, the red and blue LED light
will flash twice
. The transmitter calibration
is
complete.
Normal Operation:
Blue and Red LEDs on for Forward with pause then Reverse
Blue LED on for Forward Only
As
the batt
ery voltage gets low
there is a low
voltage warning
. The
Red LED
will
blink. As Temperature get
s
to warning point, Blue LED
will
blink.
Boost timing set to z
ero
, Blue LED flashing.
Sensored alarm, the red and blue LED lights flash, ESC does not work.
Default Settings:
Operation Mode
-
For/Rev/Brake
Initial Braking
-
= Drag Brake
Drag Brake
-
5%
Brake Strength
-
80%
Voltage Cut Off -
3.2V/cell
Punch Profile
-
Level 7
Neutral DeadBand -
3%
Boost Timing -
0 deg
Reverse Speed
-
75%
Drive Frequency
-
8KHz
Brake Frequency
-
1KHz
Temperature Set
-
On
