Floor Screed Machine HD 50
13
www.utiform.com
departamento.té[email protected]
Tfno. + 34 96 570 29 82 Fax: + 34 96 570 29 83
Do not carry out welding work on the axle.
3.3.9
Pneumatic
Wheels
When changing the wheel, ensure that the correct axle housing corresponds to the wheel couplings.
•
Tighten the ball screws with the turning moment marked
•
The tires should correspond with the axle specifications.
3.3.10 Inertia
brake
Only have brakes repaired in an authorized garage and only use original parts
The wheel brakes fulfill the regulations on toxic substances and EU regulations.
3.3.11 Brake supports and blocks
Fix the wheels with both brake blocks, both on flat surfaces as well as on slopes to prevent the vehicle from
rolling.
3.3.12 Trailer lights system
The light bar is available in the version for 7 pole plug from 12 V and 24 V. This light system is assembled
as follows:
•
Take the light bar and place it at the back of the machine, attaching it with the two spring pins
designed for the purpose.
•
Take the lighting cable with its normalized pug for the lighting bar, and connect to the 7 port base on
the side of the machine.
•
Connect the plug to the front of the trailer in the area of the tow shaft and connect it to the traction
vehicle.
•
For dismantling carry out the process in reverse.
If a 12 V traction vehicle is used, the cable may be immediately connected to the vehicle.
If a 24 V traction vehicle is used, a 12 V to 24 V adaptor is required (consult us providing item reference)
If driving a vehicle with a EURO plug, 12 V to EURO adaptor is required (consult us providing item
reference)
