Floor Screed Machine HD 50
37
www.utiform.com
departamento.té[email protected]
Tfno. + 34 96 570 29 82 Fax: + 34 96 570 29 83
8.7 Operating
Instructions
•
The INITIAL START UP and the FIRST SERVICE shall be carried out by UTIFORM service
technicians.
•
The unit should be sited in the workplace on as level a surface as possible, ensuring that
horizontal and transversal slopes do not exceed 15º. For steeper slopes, consult UTIFORM service
department.
•
Face the motor compressor so that air and wind currents do not transport dust and dirt towards
it.
•
Keep the compressor as far away as possible when working with sand blasting, grinding
machines etc.
•
Keep the machine separate from walls or enclosures where cooling air cannot easily circulate.
You should avoid recirculation of air as this could trip the temperature safety devices.
•
If working under cover or in closed premises, take the exhaust pipe outside,
making sure it is the right size for the motor to function correctly and avoiding the
production of noxious atmospheres.
•
Check the fuel deposit. Fill, if required, using a reputable brand of diesel and
ensuring that no dirt enters the tank.
•
Remove any water and dirt from the fuel filter.
•
Ensure that the oil levels in the compressor and the motor are adequate,
NEVER EXCEED THE MAXIMUM OIL LEVEL. ADD OIL THROUGH THE FILLING PIPE IF
NECESSARY. NEVER MIX OILS OF DIFFERENT TYPES OR BRAND.
Do not release the filling cap when there is pressure inside the tank.
• Clean the aspiration filter.
• Ensure that the battery is properly charged.
• If necessary, fill to the required electrolyte level, always using distilled water.
• Check that the terminals are clean and tight.
8.7.1.- Instructions for start up of dry charged batteries.
Safety recommendations
•
Do not allow any sparks in the vicinity of the battery and do not use any flame or have
flammable objects near to the battery (risk of explosion)
•
Use protective glasses and gloves when handling electrolyte. If the electrolyte comes into
contact with the skin, wash with plenty of soap and water, in the case of ingestion do not induce
vomiting, but drink water or milk to neutralize the acid and consult a doctor, in the case of fabric, soak
the affected area in a solution of bicarbonate of soda or ammonia.
•
Do not leave the electrolyte, even when the container is empty within the reach
of children.
•
Do not use the electrolyte container for any other purpose and wash it out before
discarding. Remember that there are people who collect items from rubbish bins.
Charging procedure
•
Start up of the battery, and its subsequent mounting on the compressor should be carried out
when the machine will be functioning for sufficient time for the battery to be on full charge.
•
Remove the plastic caps on the battery and, using the plastic funnel, add the electrolyte included
in the kit to the level of 20 or 25 mm. above the plates.
•
Leave the battery in repose for 20 or 30 minutes, after which, gently shake the battery to
