Floor Screed Machine HD 50
9
www.utiform.com
departamento.té[email protected]
Tfno. + 34 96 570 29 82 Fax: + 34 96 570 29 83
3 Transport
3.1
Special safety indications
• If there is a machine change on site, the mixing and transport tanks should be empty and the machine parts
should not be pressurized.
• Only use an appropriate transport or traction vehicle with sufficient towing load and support.
• Correctly attach the hook to the traction vehicle.
• For safety reasons the trailer should only be moved by two people. Make sure there is always another person
at hand to help.
• If the machines are new or the wheels have just been changed, retighten the screws of the wheels after
travelling a few miles with the rotation moment marked.
3.2
Crane Transport
When moving a machine from site with a crane, the machine has to be attached at two points on his
back and a point at its front. View recommended lifting kit fromUtiform
.
- Remove or attach all loose parts which could fall when the machine is lifted.
- A technical expert should remain close to the crane driver or should be in contact with him by megaphone.
- Then hang the machine on the crane.
- For raising the machine, use hoisting equipment and machinery with the appropriate capacity.
- Check beforehand that this equipment has been serviced and approved according to local security
regulations.
- If the machine or machine parts are lifted using one or several hoisting openings, loading hooks and shackles
should be used. Do not place cables, chains or ropes directly in the hoisting openings.
- Never use bent loading hooks etc. and attach them in such a way that they are always subject to force in
alignment with the axis of the load support.
- In this case a beam may be placed between the hoist and the load. Also two hoists may be used, bearing in
mind that these cannot be inclined at an angle of more than 30º against the vertical. The support capacity of a
hoist diminishes if the lifting force is not vertical.
- In all cases attach the machine in such a way that it can be vertically lifted and cannot rotate or overturn.
- Be careful with the load and do not work too fast. Acceleration and deceleration should be within reasonable
limits.
- Do not leave the load hanging in the hoist.
- Ensure that no one is in the danger zone surrounding the load.
