Floor Screed Machine HD 50
40
www.utiform.com
departamento.té[email protected]
Tfno. + 34 96 570 29 82 Fax: + 34 96 570 29 83
9.
Change broken or worn couplings; always keep them clean.
10.
Never use a screwdriver for opening, punching, engraving, furrowing or scraping.
11.
Use the appropriate screwdriver for each job. It should enter the screw or bolt perfectly. A
screwdriver with rounded edges slips easily. Sharpen it or throw it away.
12. Never use a screwdriver or any other tool near a low tension cable or other electrical
components. The plastic covering of handles is an improvement to the tool and is not insulation
material, unless expressly indicated as such by the manufacturer.
13. Never hit a hardened object with a hammer: place an intermediate non-hardened part between
the object before hitting it.
14.
Do not use a hammer with a loose head. Throw away any hammer with a chipped head
.
15. Never use an engraving tool or die which has a chipped surface.
16. Always wear ocular protection when carrying out any work involving hitting, scarping
engraving or sharpening.
17. Wear protective gloves when using an engraving tool or die.
The following tables show the maximum Torque Md Nm at a coefficient of friction = 0.14 m total,
with the screw lightly oiled or greased
For glue fixing screws are in place all the previous pairs of tightening by a factor of 1.1.
