Floor Screed Machine HD 50
30
www.utiform.com
departamento.té[email protected]
Tfno. + 34 96 570 29 82 Fax: + 34 96 570 29 83
•
Take precautions to avoid inhalation of toxic steams in cleaning liquids.
•
If you use a steam cleaner, protect delicate machine parts from moisture.
•
Completely cover the electric motor, the light machine and other electric components, and
regulation devices.
•
After cleaning, check all the fuel, motor oil and hydraulic oil conducts as there may be leaks, worn
areas and damage. Repair any damage immediately!
•
Remove dirt from inside the machine in following work, covering the parts and openings with a
clean rag, or masking tape.
•
Remove coverings / tape immediately after cleaning.
•
Clean the machine daily so that it does not become encrusted with dirt which could affect the
functioning of important components.
•
Do not try to put your hand inside the mixer or stirrer when the motor is running, even thought the
mixer or agitator is stopped.
•
Spray the machine with preservative after cleaning. Do not allow rust to form and protect the
machine taking care not to attack rubber parts, cables and joints.
•
Do not expect to have any guarantee for the aforementioned parts if you use other cleaning methods,
particularly diesel fuels.
• Wash the outer part of the machine with water and a brush.
Cleaning the mixer tank and the transport hoses.
Raise the protective grille on the mouth of the tank and bend it to one side. Carefully wash the mixer
tank interior with plenty of water so that no mortar or other material remains.
WARNING!
Take particular care with the ends of the vessel axle as there must not be any incrusted
dirt on the mixer axle joints. This would harm them and would eventually cause significant damage.
Place the outlet receptacle in a place where the dirty water can drain out without causing any
damage.
Close the lid of the tank, start the machine and flush out the dirty water through the transport hoses
and the material outlet recipient.
Ensure that the material outlet receptacle is stable and secure as the remains of mortar, water for
washing and pressurized transport air will come out.
Rinse the mixer tank a second time fill it half full with water and empty it again, as described above.
For a final cleaning of the transport hoses, use rubber cleaning balls (ref. 3500180) passing them
through to eliminate any remains of mortar which may still be inside. Repeat this process as often as
necessary until completely clean water runs out of the pipes.
We recommend cleaning the air hoses entering the vessel and at the material outlet. The process is simple and all that
is required is to disconnect both hoses with GEKA and clean its insides with water.
7.11
Faults in material transport
The mixture does not pass through
If the material is not passed quickly through the transport hose, it means there is a fault.
•
Close the upper and lower air taps. In this way you will prevent air from escaping from the empty
transport pipe.
•
Disconnect the machine and secure it to prevent unauthorized connection
•
Eliminate the cause e.g. the mixture ingredients have not been adequately constituted.
A blockage in the transport hose
