UTC Fire and Security DET-TRONICS 95-8533, Инструкция по эксплуатации

Страница: 96 / 146

7.1 95-8533 4-22
Ground Fault Monitor
Verify earth ground connections as specified in the
wiring instructions.
Check power distribution to ensure that all devices
are receiving power.
DCUs
Verify correct address setting.
Check modules for correct orientation.
Check for the presence of contaminants or poisoning
agents.
Device should be oriented with the sensor pointing
down.
IDCs
Verify correct address setting.
Check for correct installation of EOL resistors.
ARMs
Verify correct address setting.
Check jumpers.
SAMs
Verify correct address setting.
Check signal circuits for correct polarity.
Check for correct installation of EOL resistors.
Check jumpers.
GENERAL START-UP PROCEDURES
1. Output loads that are controlled by the system
should be secured (remove power from all output
devices) to prevent actuation.
2. Check all system wiring for proper connection.
3. Inspect all devices to verify that they have not
been physically damaged in shipment.
4. Apply power to the system.
Note
to prevent the network modules from going into
a fault isolation condition, apply power to the
eQP Controller prior to applying power to the
network devices.
5. Program the system for the desired operation
using Det-Tronics Safety System Software (S3).
Download configuration data to all devices.
Note
After system configuration has been completed,
the entire system should be tested for proper
operation to ensure that configuration was
performed properly.
6. Calibrate the sensors.
7. Ensure that all trouble and alarm conditions have
been cleared and the EQP Controller is reset, then
remove mechanical blocking devices (if used)
and restore power to the output loads.