Tyco DSC WK250, Руководство по установке, Страница: 7 / 92

2. Installation
D-306488 WK250 Installer’s Guide 7
2.5 Enrollment of the First WK250 Keypad in WP8033
The WP8033 is designed to operate wirelessly with the WK250 keypad installed anywhere within the protected
premises.
The first keypad is always enrolled as Keypad no. 1.
Note:
The enrollment procedure described here is for the first WK250 keypad only. The enrollment of additional
keypads is performed by the first enrolled WK250 keypad (for instructions, see section 3.4.2).
Step Action
1
Press the "ENROLL" button (physically located inside the front unit of the WP8033 control panel – see Figure
3.1 in the WP8033 Installer Guide) for 2 seconds. If no keypad exists in the first location, the "ENROLL" LED
on the WP8033 blinks slowly for one minute (go to step 3).
If a keypad already exists in the first location, the "ENROLL" LED on the WP8033 control panel lights steady
for 10 seconds (go to step 2).
Note: Pressing the "ENROLL" button takes the system out of any menu mode (Installer Mode, User Settings
and Periodic Test).
2 Press the "ENROLL" button again within the timeout period (10 seconds). Any keypad that was enrolled in keypad
no. 01 is deleted from the system.
The "ENROLL" LED on the WP8033 blinks slowly for 1 minute.
3
During this 1 minute period, hold the button on the WK250 keypad for 5-7 seconds until the LED
on the keypad lights red, and release
1
. The "ENROLL" LED on the WP8033 will indicate the result of the
enrollment procedure.
WP8033 “ENROL” LED indication Result
Blinks fast for 5 sec. Successful enrollment of keypad
Lights steadily for 5 sec. Wrong device type
4 Upon completion of the enrolling procedure, the keypad is ready for immediate use even if the system is
currently in the Armed state.
Note:
If the keypad was previously enrolled, it will be relocated automatically to Keypad no. 1. However, all of
the configured parameters will be lost and the keypad will revert to the default parameters .
1
If the WK250 unit is battery-powered: first press any button on the WK250 keypad momentarily to take the WK250
keypad out of sleep mode and then hold the button for 5-7 seconds, until the LED on the keypad lights
red, and release.