3. Programming
D-306488 WK250 Installer’s Guide
51
Option and default
Configuration Instructions
“VIEW TIME WINDOW” menu
appears only if an option other
than "disable" is selected in
“VIEW ON DEMAND”
arming modes (i.e. "Always") or restricted only to a specific limited time window that
follows an alarm event.
Options:
always
;
alarm + 5 min
;
alarm + 15 min
;
alarm + 1 hour
VIEW OTHER ALARM
enable
Define whether the system will capture and forward image clips also upon occurrence
of Non-Burglary alarms (i.e. Fire, Duress, Emergency and panic).
Options:
enable; disable.
3.6.7 Configuring Upload / Download Remote Programming Access Permission
Using a PC, the WK250 can be configured (by upload/download) either locally or from remote via PSTN telephone line
or GPRS cellular communication.
•
Local programming
can be performed by directly connecting the computer to the panel's serial port using the
Remote Programmer PC Software.
•
Remote programming via PSTN
can be performed by using a modem and the same software. The modem dials to
the control panel and establishes a connection via PSTN using an agreed process. When connection is established, the
installer or Master installer can access the panel using the UL/DL access codes programmed in the
"
PSTN UP/DOWNLOAD
" menu – see table below. For further information refer to the "WP Remote Programmer
Software User's Guide".
Remote programming via GPRS
is performed using a PowerManage server and related Remote Programmer PC
software. The PowerManage server calls from a cellular modem to the Panel's SIM card number. The panel checks the
caller ID and if identical with any of the two callers ID 1 or 2 programmed in the "
GPRS UP/DOWNLOAD
" menu (see table
below), the panel initiates a GPRS connection with the respective IP Receiver 1 or 2 (as configured in section 5.6.4 options
21 & 22). When connection is established, the monitoring company can perform the upload/download procedure via the
established secured GPRS connection. For further information refer to the PowerManage User's Guide
In this section you can configure the access permissions (i.e. security codes and identification) and determine the
functionality of the upload/download procedures via PSTN and GPRS channels.
04:COMMUNICATION
⋅ ⋅ ⋅
6:UP/DOWNLOAD
⋅ ⋅ ⋅
MENU you wish
Enter "
6:UP/DOWNLOAD
", select the menu to configure (see guidance above and in section 3.6.1), and then refer to
the table below for configuration instructions.
Option and default
Configuration Instructions
PSTN UP/DOWNLOAD
Configure the Upload/Download functionality via PSTN. The functionality is determined
through a sub-menu of the "
PSTN UP/DOWNLOAD
" option as shown below.
To program:
Press
to enter the "
PSTN UP/DOWNLOAD
" sub menu and then select and
configure each of the sub-menu options as shown below. When done, press
to
return.
Remote access
enable
Enable or disable the
remote access
to the system. If disabled, the system cannot be
accessed
remotely thereby inhibiting the Upload/Download and the Remote Control via
PSTN or GSM analog communication channels (refer to the WK250 User's Guide,
Chapter 7).
Options:
enable
;
disable.