3. Programming
D-306488 WK250 Installer’s Guide
43
disable
via the
SMS
Channel. For further information, see section 3.6.4 options 26 & 27.
Options:
disable
;
enable.
GPRS APN
Enter the name of the
APN Access Point
used for the internet settings for the
GPRS
(up to 16 digits string).
Note:
To enter the APN Access Point
,
use the “String Editor” in section 3.8.1.
GPRS USERNAME
Enter the
Username
of the
APN
used for
GPRS
communications (up to 16 digits
string).
Note:
To enter the Username
,
use the “String Editor” in section 3.8.1.
SIM PIN CODE
Enter the
PIN code
of the
SIM card
installed in the
GSM
module (up to 8 numerical
digits).
Note:
To enter the numerical PIN code, use the numerical keyboard.
GPRS PASSWORD
Enter the
Password
of the
APN
used for
GPRS
communications (up to 16 digits
string).
Note:
To enter the Password, use the “String Editor” in section 3.8.1.
NETWORK ROAMING
roam enable
You can force the SIM card to use only its "Home Network" and disable it from roaming
to other networks in case the Home Network cannot be found.
Previously known as
"FORCE HOME NTWK"
Options:
roam disable
;
roam enable
.
GPRS ALWAYS ON
disable
Define whether the control panel will stay continuously connected "
enable
", via GPRS
communication, or disconnect "
disable
", after each report session.
Previously known as
"SESSION TIMEOUT"
GSM KEEP ALIVE
every 28 days
Some GSM Service providers tend to disconnect the GSM connection if the user has
not initiated any outgoing telephone calls during the last 28 days. To prevent from
disconnecting the GSM connection, you can configure the system to generate a
"keep
alive"
GSM
call
every 28 days
sending a test message either to the first SMS number
(if exists) or alternatively first private telephone number.
Options:
disable
or
Every 28 days.
TRANS PROTOCOL
TCP
Select the type of protocol used by the control panel to transfer data over the internet.
Options:
TCP
; or
UDP.
Note:
A change of option should be performed in coordination with tech support.
3.6.4 Configuring Events Reporting to Monitoring Stations
The WP control panel is designed to report alarm, alerts, troubles and other events and messages to two Monitoring
Stations C.S.1 and C.S.2 via PSTN telephone line, Cellular i.e. GSM voice (analog), GPRS (IP) & SMS or Broadband IP