3. Programming
D-306488 WK250 Installer’s Guide
47
Option and default
Configuration Instructions
53:COM.FAIL RPRT
Determine whether a failure in any of the system communication channels i.e. PSTN
or GSM/GPRS will be reported or not and the time delay between detection of the
failure and reporting of the failure event to the Monitoring Station. A trouble event (i.e.
"tel line fail", "GSM line fail” or “broadband fail") will be respectively stored in the event
log.
PSTN FAIL
immediate rprt
GSM GPRS FAIL
do not report
(Return)
Previously known as "LINE
FAIL REPORT"
Options "
PSTN FAIL
":
immediate rprt
;
after 5
/
30
/
60
/
180 min
and
rprt disabled
.
Options "
GSM GPRS FAIL
":
after 2
/
5
/
15
/
30 min
and
do not report
.
61:RPRT CNF ALRM
rprt disabled
Define whether the system will report whenever 2 or more events (confirmed
alarm) occur during a specific period or enable the report and bypass the
detector.
Options:
rprt disabled
,
rprt ena+bypass
and
rprt enabled
Note:
In some WP variants, this menu is displayed in the Operation Mode only.
62:RECENT CLOSE
rprt disabled
False alarms may occur if users do not exit the premises within the exit delay
period, resulting in a false alarm a short time later. In such cases, inform the
Monitoring Station that the alarm occurred shortly after the system was armed
(this event is known as "Recent Close"). The report enabled option sends a
“recent closing” report to the Monitoring Station if an alarm occurs within 2
minutes from the end of the exit delay.
Options:
rprt disabled
and
rprt enabled
63:ZONE RESTORE
rprt disabled
Some Monitoring Stations require that following an alarm event from a specific
zone, the system will also report when the alarming zone has restored to normal.
Options:
rprt enabled
and
rprt disabled
64:SYST.INACTIVE
rprt disabled
The WP can report a "System Inactive" event message (CID event 654) to the Monitoring
Station if the system is not used (i.e. armed) during a predefined time period.
Options:
rprt disabled
;
after 7/14/30/90 days
.
65:TWO WAY VOICE
You can configure the two way voice channel settings of the control panel
, as
follows:
Send 2 WV Code:
Define whether the system will send two-way voice code to the
1
Refers to WP8030 with voice option.