3. Programming
50
D-306488 WK250 Installer’s Guide
3.6.5 Configuring Events Reporting to Private Users
The WP system can be programmed to send various event notifications such as alarm, arming or trouble events, to 4
Private telephone subscribers using audible signals and if a GSM option is installed, the system can send the messages
also to 4 SMS telephone numbers. These reports can be programmed either instead of or in addition to the reports
transmitted to the monitoring company. In this section you configure:
•
The specific events you wish the system to report.
•
The 1
st
, 2
nd
, 3
rd
, and 4
th
Private telephone and SMS numbers of the private subscribers.
•
The number of redial attempts, two-way voice communication
and your preferred acknowledge method i.e. whether
a single acknowledge signal will stop the reporting process or an acknowledge signal from each telephone will be
required before the reported event is considered reported.
To select and configure an option follow the instructions below. Additional guidance is provided in section 3.6.1.
04:COMMUNICATION
⋅⋅⋅
4:PRIVATE REPORT
⋅⋅⋅
MENU you wish
•
The "
4: PRIVATE REPORT
" menus and sub-menus configuration is shown in the table in section 3.6.1. For a
detailed description of the menus options, refer to the WK250 User’s Guide, Chapter 6, section B.12.
3.6.6 Configuring Motion Cameras for Visual Alarm Verification
If equipped with a GSM/GPRS module, the WP can communicate to Monitoring Stations (equipped with PowerManage
server) via the GPRS network, also with image clips captured by Motion Cameras (models Next CAM PG2, Next-K9
CAM PG2 and TOWER CAM PG2). The Monitoring Station can use the video clips for verification of Burglary alarms
detected by the Motion Cameras. The system can be configured to capture image clips also upon occurrence of Non-
Burglary alarms (i.e. Fire, Duress, Emergency and Panic). The server can then forward the images to the management
computer of the monitoring station or to 4 remote computers via e-mail and/or 4 mobile phones by MMS images.
In addition, the monitoring station can log into the PowerManage server and request the system to provide image clips
"On Demand" and to forward them as defined in the PowerManage application. To protect customers' privacy, the
WK250 can be customized to enable the "On Demand View" only during specific system modes (i.e. Disarm, Home and
Away) and also to a specific time window following an alarm event. In this section you can program the 4 e-mail
addresses and mobile phone numbers to which the images will be forwarded and to configure the parameters of the "On
Demand View".
04:COMMUNICATION
⋅⋅⋅
5:MOTION CAMERAS
⋅⋅⋅
MENU you wish
Enter "
5:MOTION CAMERAS
", select the menu you wish to configure (see guidance above and in section 3.6.1), and
then refer to the table below which provides you with detailed configuration instructions.
Option and default
Configuration Instructions
VIEW ON DEMAND
disabled
By enabling the "On Demand View", you can determine during which arming modes
(system states) the "On Demand View" will be permitted. In the next option "VIEW
TIME WINDOW" you can determine when, during the permitted arming modes, the
"On Demand View" will be enabled.
Options:
disable
;
in all modes
;
in AWAY only
;
in HOME only
;
in HOME & AWAY;
DISARM & AWAY
;
DISARM & HOME
; and
in DISARM only
.
VIEW TIME WINDOW
always
If the "On Demand View" is enabled in the previous option, you can further determine
whether the "On Demand View" will be possible at any time during the selected
1
Refers to WP8030 with voice option.