3. Programming
42
D-306488 WK250 Installer’s Guide
Enter "
1:PSTN TEL LINE
", select the menu you wish to configure (see guidance above and in section 3.6.1), then refer
to the table below.
Option and default
Configuration Instructions
AREA CODE SKIP
In some older PSTN networks, it may not be possible to dial from the control panel to
other PSTN telephone numbers (such as monitoring stations or private phones), if the
dialed number contains an area code which is identical to the area code of the panel
(i.e. both the panel and the other numbers are in the same PSTN area code).
If you encounter the same problem with the PSTN network the panel is connected to, you
must enter here the area code of the PSTN telephone line to which the panel is connected
(up to 4 digits) so that when dialing to other PSTN phone numbers programmed with the
same area code, the alarm system will skip the area code from the dialed number.
LINE PREFIX
Enter the prefix digit (if necessary) for the system to access an outside telephone line.
DIAL METHOD
tone (dtmf)
Define the dialing method used by the PSTN dialer of the WP control panel.
Options:
pulse
and
tone (dtmf)
.
3.6.3 Configuring GSM-GPRS (IP) - SMS Cellular Connection
The GSM/GPRS module is capable of communicating with the Monitoring station receiver by GPRS, GSM Voice
(analog) or SMS Channels.
Each of the channels can be separately enabled or disabled to allow or prohibit the module from using it for the event
reporting. If all channels are enabled, the GSM/GPRS module will always try GPRS first. If fails, it will try GSM voice. If
fails, it will try any other possible method (PSTN Broadband) and only then it will try SMS. Disabling any of the GSM
channels will cause the module to use a different sequence than the one described above.
04:COMMUNICATION
⋅⋅⋅
2:GSM/GPRS/SMS
⋅⋅⋅
MENU you wish
Enter "
2:GSM/GPRS/SMS
", select the menu you wish to configure (see guidance above and in section 3.6.1), then refer
to the table below which provides you with detailed explanations and configuration instructions for each option.
Option and default
Configuration Instructions
GPRS REPORT
disable
Define whether the system will report events to the Monitoring Stations using the
GPRS (IP)
Channel. For further information, see section 3.6.4 options 21 & 22.
Options:
disable
;
enable.
GSM REPORT
disable
Define whether the system will report events to the Monitoring Stations'
Alarm Format
receivers
via the
GSM Voice (analog)
Channel. For further information, see section
3.6.4 option 41.
Options:
disable
;
enable.
SMS REPORT
Define whether the system will report events to the Monitoring Stations'
SMS receivers