Tyco ADT16E, Руководство пользователя

Страница: 18 / 83

User’s Manual
8
CAUTION: When using the Factory Reset , you will lose any setting you have made. If
you want to use the same DVR name registered on the DVRNS server after initializing
the system using the factory reset, you need to contact the DVRNS server manager.
Please record and save the help desk information before factory reset.
To reset the unit, you will need a straightened paperclip:
1. Turn the DVR off.
2. Turn it on again.
3. While the DVR is initializing, poke the straightened paperclip in the unlabeled hole to the right
of the USB port.
4. Hold the switch until all the LEDs on the front panel are lit.
NOTE: When the DVR successfully resets to factory defaults all the LEDs on the front panel flash
three times.
5. Release the reset switch. All of the DVR’s settings are now at the original settings it had when it
left the factory.
Connecting the Power Cord
Figure 15 — Power cord connector.
Connect the DC power cord of the adaptor to the DVR, and connect the AC power cord to the adaptor and
then to the wall outlet.
NOTE: The power cord connector locks into position to prevent accidental power loss. Be sure to
slide the release away from the socket before removing the plug.
WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING HAZARD.
MAKE CERTAIN THE POWER CORD WILL NOT BE PINCHED OR ABRADED BY
FURNITURE. DO NOT INSTALL POWER CORDS UNDER RUGS OR CARPET.
THE POWER CORD HAS A GROUNDING PIN. IF YOUR POWER OUTLET DOES NOT
HAVE A GROUNDING PIN RECEPTACLE, DO NOT MODIFY THE PLUG.
DO NOT OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY DEVICES IN TO ONE
CIRCUIT.
Your DVR is now ready to operate. Refer to Chapter 3 — Configuration and Chapter 4 — Operation .