Installing the System
MicronNav System
0656-SOM-00001-07
35
© Tritech International Ltd.
Selecting External Heading/Pitch/Roll data in Job
After configuring a COM Port for the External data input (Section 3.2.7, “Connecting optional
third party High Accuracy Heading/Pitch/Roll MRU Sensors”), to then apply External Heading/
Pitch/Roll data, i.e. from a Ship Compass or MRU, it must be selected in the Job.
A Job should first be created to create the operational environment for the Navigation system
to work in (Section 4.1.4, “Creating a New Job (Using Wizard)”). If a Job is currently created
and loaded then it is also possible to edit this Job to make and save necessary changes
(Section 4.1.5, “Editing an Existing Job”). The example below will show the configuration that
needs to be done during an Edit Job (N.B. The same selection controls will be found when
Creating a new Job).
To apply External Heading/Pitch/Roll data, select MicronNav from the top menu bar and
select Job – Edit Job to open the
Edit Job
panel (as shown below - if this menu option
is not displayed click inside the Navigation window first). Then follow a couple of Steps to
make the necessary configurations.
Step 1: In the
Job Setup
tab-page, set the Heading drop-down selection to
Use Ship
Compass
